2022 gear has arrived! (Most of it.) Free Shipping in the U.S. on all orders over $50. Save on closeouts.


Your Cart is Empty

Ultra Heel Cover Plates


Replacement aluminum heel cover plates for Ultra World Cup, Ultra and ZR bindings.

The replacement heel pin cover plates are available singly or in sets of two with retention screws and washers.

Check and adjust the tightness of the Heel Pin Cover System periodically. Heel Pin Cover Plate rotation needs to be sufficiently tight so that the plate stays in place, either fully closed (uphill mode) or fully open (downhill mode). Adjust the tightness of the cover plate with a #10 Torx wrench. If the plate is too loose, it can rotate into a upright position, and subsequently break when a boot steps down on it.

Heel pin cover plate breakage is not covered under warranty, as it is usually preventable with simple regular maintenance, but we provide these replacement cover plates at low cost.